SC 1.1 LS MONOBLOC single flame oil burner RANGE
SC. 1.1 LS |
|||||
|---|---|---|---|---|---|
| Power | Kw/h | Min | 18 | ||
| Max | 140 | ||||
| kcal/h | Min | 15.480 | |||
| Max | 120.400 | ||||
| l/h | Min | 2 | |||
| Max | 10 | ||||
| Feeding | 1N-50 Hz 230V | ||||
| Engine Kw | 0,15 | ||||
| Gas Inlet Pressure mbar | 21-300 | ||||
More information
- Duoblock burners with high temperature steel housing and combustion head.
- The following fuels can be used: Light oil, viscosity 6 mm2/s at 20°C, PCI11.86 kWh/kg
- It is suitable for steam, hot water boiler, furnaces, dryers, thermal oil generators, etc.
- Each burner can be customized to the needs of the installation.
- Reduction of intervention time during maintenance operations:
Electrical components with plug-in connectors
Full accessibility to the aeraulic circuit and combustion head
- Flame control is simple and reliable thanks to the photocell.
- A customized type of sensor is used for sequential installation of multiple generators.
- The ease of design and the use of preheated combustion air while allowing energy savings by increasing the efficiency of the combustion economizer used by the system.
- It has the characteristics of good performance in different combustion chambers.
- It minimizes the specific amount of nitric oxide (NOx) gas emission by obtaining an optimal fuel air mixture thanks to the customized design of its combustion head.
- It provides easy installation and operating conditions in confined spaces thanks to its compact dimensions.
- Allows operation in high back pressure combustion chambers by placing a high pressure venting system.
- Standard protection of mechanical parts IP 54.
- IP 65 protection on request.
- The flame geometry can be adjusted according to the combustion chamber.
- Compliance with the following directives:
89/336 (2004/108)
EEC 73/23/ EEC 73/23/ EEC 73/23/ EEC 73/23/ EEC 73/23/ EEC 73/23/ EEC 73/23
EEC 98/37/
CEE EN 676
English 
Español 
Français